Safecoat Hard Seal

Safecoat Hard Seal is a multi-use, clear gloss sealer especially formulated to provide mar resistance to both low and high porosity surfaces. Because it forms a continuous membrane when applied properly it is particularly effective at sealing in any pollution or toxic chemical compounds outgassing from the surface to which it is applied.

USE ON - Typically used on previously uncoated and unsealed woodwork, cabinetry and vinyl tile. To prevent outgassing of previously coated surfaces, can also be applied over existing paints, stain and colorfast wallpaper. When applying to a previously coated surface test in inconspicuous places for satisfactory appearance. Not for use on particle board or chipboard.

APPLICATION - Always have adequate ventilation. Before using, mix coating thoroughly by gently stirring or rolling container to avoid air bubbles. Be sure to stir product thoroughly every 20 minutes during application. Do not shake container. Pour material to be used into another container before applying coating to avoid contaminating main container. Then apply as is, using a quality nylon brush, pad applicator, or unheated spray applicator. Apply liberal coats, keeping a good wet edge and avoid overbrushing. In most cases, a minimum of 2 coats is required, depending on the surface. When spraying, use a .015 tip or smaller. Apply thin even coats when spraying rather than heavy coats which will tend to sag. If spray pattern begins to dryspray, reduce air pressure and increase material flow to surface. Use a damp, dust free rag after sanding to remove dust particles. Use aluminum oxide or silicon carbide sandpaper to sand between coats. For best results, this product should not be reduced. Use only during low or moderate humidity conditions. Applying this product over lightly dampened surfaces can assist the user in controlling the dry time. Smoother finishes are achieved when surfaces are damp during application. For best results, this product should not be reduced. Note: these instructions are intended to be general only and not exhaustive. The applicator should determine what preparation and techniques are best suited to the specific surface.

COVERAGE - One gallon of Safecoat Hard Seal covers approximately 350 square feet in one coat depending on surface porosity.

DRYING/CURING TIME - Under normal conditions, Safecoat Hard Seal dries to touch in one hour and is re-coatable after 2 hours. Normal conditions include a dry surface, access to fresh air flow, moderate humidity, and temperatures above 55°F. Thick application, high humidity or conditions other than normal will cause Safecoat Hard Seal to dry and cure more slowly.

SPEC SHEET

****AFM Safecoat Products ship via UPS ONLY and can have up to a week lead time - particularly for larger orders